Create your music box
People who like to relish a challenge and love to perform crafts that are creative and producing your music box may contain a lot of fun. Here are instructions to produce an exceptional music box called”round the world.
Things you Want
Unfinished recipe box of 5 3/4 broad * 3 3/4″deep * 4″ large 18 note key breeze musical motion T pub winding key, 3/4″ De’ coupage sandpaper timber sealer. Cosmetic accessories for the audio box like a range of stamps, greeting card or postcard with travel photo 2 brown ultra sued strips, 1/2″ broad * 16 1/2″ extended two buckles, 1/2″ 4 brass corner mounts, 5/8″ hasp capture, 1 3/4 * 5/8″ little padlock.
Acrylic paint color: blue-gray, adhesives and spray dyes, industrial-strength adhesive tacky adhesive gloss spray dyes, tools, and brushes, drill using 1/4″ drill piece hammer older paintbrushes paintbrush strand scissors X-acto knife.
Collect step
- Use sandpaper, sandbox and use an old paintbrush, by following the instructions of the manufacturer, use the wood sealer. Permit drying.
- Use a paintbrush out and inside with paint.
- By employing an older paintbrush, apply a thin coating of decoupage into box and faces of the lid, working a place of approximately 3″ square at one time. Put stamps on the lid and box sides, overlapping them. So it could be trimmed open 19, stamps need to be placed within the opening between box and lid. Use a ruler cur card, and an X-acto knife to match the box’s cover. Apply a coat of decoupage to put card and lid in position.
- Apply a thin coating of glue that is sticky to the side of a single ultra suede strip. Start in the front left corner, 3/4″ from 1 and side 1/2″ in the base, press strip into the box. Twist a buckle and create a little hole to accommodate the stalk of the buckle in center 1″ in the end. Cut corners of this ultra suede strip onto a 45-degree angle. Repeat the procedure for the rest of the suede strip onto a 45-degree angle. Repeat the procedure for the rest of the suede strip on the side of this box. Permit drying.
- Use the knife and cut the gap between the lid and the box.
- Then drill a 1/4″ hole in the middle rear of box 3/4″ in the bottom. Use glue motion inside the box, strong adhesive, ensuring that the secret shaft is based in the pit. Allow it to dry.
- Gently hammer on the corner mounts. Turn the box back, center hasp hammer and carefully grab. Then pull on the padlock on twisting key and end. Fill out your box.
